Problem Jog only works on Y,X does nothing mach 3 - CNCzone.com-The Largest Machinist Community on the net!

555e · #1 03-06-2010, 06:32 PM

I am setting up another computer with mach 3 running win 2000 on a dell, i already have it running on XP on another computer. I have changed the bios settings every way i can think of but i cant get X to do anything I can unplug My 2 axes board and plug it in to the xp computer and everything works perfect any one have any ideas ? Mach screen shows its moving!

jalessi · #2 03-06-2010, 06:39 PM

555e,

Try installing a clean copy of Windoz XP

Jeff...

555e · #3 03-06-2010, 07:01 PM

My XP PC works fine my problem is with my windows 2000 PC Its a fresh install with a good check sum.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Only Y works correct X don't work Z works one direction only	jdgbadenhorst	Hobbycnc (Products)	1	05-20-2012 06:26 PM
scanner that works with Mach	pike88	Digitizing and Laser Digitizing	9	05-19-2009 07:22 AM
Mach 2 Works, Mach 3 Doesn't	mrcosmos	Mach Software (ArtSoft software)	9	07-27-2008 03:12 PM
Bit for Works	auvecu	CNCzone Club House	0	07-02-2007 12:58 AM
Confused: Mach Turn, Mach Mill, Mach 2/3 ?	CanSir	Mach Software (ArtSoft software)	5	02-16-2007 04:41 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)