Dear everyone,
Could you help me to solve my Mach3 motion card problem?
I buy a China Wood lathe machine 5 months ago.
A day, I still started the machine as normal, but when open the Mach3 software the announce "Find No XHC NCUSBPOD!" appeared.
I checked the connection status led, it is off (Normally, it was flashing).
If I try to unplug the USB cable and plug in it again, after sometimes It will work.
It 100% happen at the start in the morning.
I have tried to keep the computer on until next morning, and the result is ok next morning (the mach3 motion card was still works).
Now I don't know what I have to do next. (Because I have to unplug and plug the USB cable every morning)
Please help me!
Give me your ideas to test.
Thank you very much!


Similar Threads: