If you have a Fagor control and the engraving add on is installed & activated and you have forgotten how to use it OR it is set up on the control and you don't know how to operate it, I have the 2 page .PDF that will get you on track. I can't accept outside E-mail at my new job so just send me a note requesting the .PDF on the Fagor engraving manual to:
wjacobs1@comporium.net and I'll send it to you.

This WILL NOT activate the engraving package in your control.

This must already be done.

This is just a manual for setting it up and using it.

Similar Threads: