I need only cable number to Fanuc - Dah Lih

Results 1 to 4 of 4

Thread: I need only cable number to Fanuc - Dah Lih

  1. #1
    Member cnc_swe's Avatar
    Join Date
    Jan 2006
    Location
    sweden
    Posts
    121
    Downloads
    0
    Uploads
    0

    Default I need only cable number to Fanuc - Dah Lih

    My Cable on X-axels was really bad condition and I look on ebay but without any spec number I was out of access.
    The Cable have 20 lines and on the servomotor it an Amphernol / Cannon Contact. Other side is an Honda.
    The machine is an DahLih MCV 510 made 1993.

    Maybe any now from where I can find the Cable. I have wrote a letter to the manufacturer but the don´t answer me

    The best is of course to find a complete original cable but also a corresponding noncontact second. The old cable was broken because of the cutting fluid that dissolved the cable cover.
    The servo motor and amplifier is manufactured by Fanuc RedTop at 900 watts.

    Probably, someone changed the cable once since the 20 pin cable is a signal cable.
    Power cable goes in a separate cable.


    I need only cable number to Fanuc - Dah Lih-cannon-contact-jpg

    Similar Threads:


  2. #2
    Community Moderator Al_The_Man's Avatar
    Join Date
    Dec 2003
    Location
    Canada
    Posts
    24216
    Downloads
    0
    Uploads
    0

    Default Re: I need only cable number to Fanuc - Dah Lih

    In most cases, especially with older machines, the responsibility for replacement cable is for the owner to obtain these by getting a technical service company to make these up, the originals are usually custom from the OEM.
    The one shown is the standard Fanuc MS connector.
    Al.

    Attached Thumbnails Attached Thumbnails I need only cable number to Fanuc - Dah Lih-fanmotor4con-pdf  
    CNC, Mechatronics Integration and Custom Machine Design

    “Logic will get you from A to B. Imagination will take you everywhere.”
    Albert E.


  3. #3
    Member cnc_swe's Avatar
    Join Date
    Jan 2006
    Location
    sweden
    Posts
    121
    Downloads
    0
    Uploads
    0

    Default Re: I need only cable number to Fanuc - Dah Lih

    Thank´s Al for the information,

    the other connector named as H20 Honda Tsushin MR connector, 20 pin. Maybe I can find this on www..



  4. #4
    Community Moderator Al_The_Man's Avatar
    Join Date
    Dec 2003
    Location
    Canada
    Posts
    24216
    Downloads
    0
    Uploads
    0

    Default Re: I need only cable number to Fanuc - Dah Lih

    There is not that many sources for Honda plugs, unfortunately, they come in two types, the solder type and the crimp pin type.
    Al.

    CNC, Mechatronics Integration and Custom Machine Design

    “Logic will get you from A to B. Imagination will take you everywhere.”
    Albert E.


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

I need only cable number to Fanuc - Dah Lih

I need only cable number to Fanuc - Dah Lih