I just inherited a Tree 325, with a cimworks dnc port. The dnc port is still connected to the 25 pin connector, but the wire from the dnc port to the pc was just cut. I have no manuals telling me anything about the wiring or set up as far as baud rate etc.
The cable from the dnc to the pc is a nine pin on both ends, And appears to have only have 4 wires connected in the past.
Any help with wiring etc. would be a great help.....thanks in advance
These connections will work for most machines. Actually the TXD, RXD, RTS, CTS and GND are the critical ones. You can jumper DCR, DSR and DCD at both ends.