Need Help with Yasnac J300 controller! Alarm codes

[drutort]

I have a Matsuura 510 with a j300 controller.
It was transported and the power has been connected but when the machine was powered on I get the 3 alarm codes.

3002 Emergency Stop
3000 Servo Off
2190 Machine Not ready

Air and oil are in the machine, and the emergency stop has been depressed both on the back of the tool changer and on the front. Have pressed on button on the control 2x

I have hit reset number of times, no luck.

I am not familiar with this controller.

Is there some kind of physical switch or parameter that needs to be turned switched? I do not know the steps that were taken or need to be taken before transportation and after.

Thank you for any feedback.

[haastec]

Can I ask what you did to clear this?

I have the same issue.

Thanks