LinkBack URL
About LinkBacks
Looks like a network error or file access error.
| | |
I have just started getting this error:
http://server2.uploadit.org/files/gatormike-error.JPG
The machine works on older programs and SOME programs that I have just written. However, I get this error on the bulk of new programs I write.
Any ideas on what is causing this and how to fix it?
Looks like a network error or file access error.
Gerry
Mach3 2010 Screenset
http://home.comcast.net/~cncwoodworker/2010.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
either that or "out of diskspace"...
I just said screw it and restored the machine to an older state with Norton Ghost. It is working fine now. I just wish I knew what could have caused it.
Check that. Machine is down again. Now I am getting a different error. Now it says "Cannot find program on hard disk d:\ww4\a1\prg\........"
So, where is the diskdrive? Is it a physical or virtual diskdrive?
I have a cnc Week 05 with 750 num kja control works nicely but when I send the G DNC machine and press start putujuje the specified codes, but does not include processing engine and when you put the M3 has provided an example of G code that would do this when the number način.Ali I put the program in the sub-dialog (starting position tiller) then do what you should write to the beginning of my code to include frezmotor
thank you
Posting Permissions
| | |
