Anyone use the FET4 board from Stepperworld?

[Norseman]

Hi
I am about to build a machine for cutting foam wings, and have a FET4 board from Stepperworld. I was wondering if anyone else is using this board, or know if this is a good board for the purpose.


Steinar

[foam27]

I would go Geckos at a minimum, my Stepper3 failed...

[Norseman]

Foam27.
Please excuse my ignorance, but if you could please tell me about what happened to you, and what Geckos is I would really appreciate it since I am a total novice in this field. I have the machine ready built now, but have not figured out the program to use for cuttting yet. Any information would make me happy.


Sincerely
Steinar

[solarchimesam]

I use FET-3 from stepperworld.
So far I like it. It works even better in Linux EMC.

JEFF

[delwart]

I use the FET-3 and love it. My son also has one.

I love it. High quality and great support. I needed resistors for some steppers I had (not stepperworld's offerings) and they promptly sent me a schematic of the stepper and suggested resistor types.

I'm sure there are other good places, but this is one I can recommend.

Dan

[joepiejan]

Originally Posted by Norseman Hi I am about to build a machine for cutting foam wings, and have a FET4 board from Stepperworld. I was wondering if anyone else is using this board, or know if this is a good board for the purpose. Steinar

I ordered one....realy sh#$ ! first they let me pay 81 euro !!! shipping cost after.And the power supply works great for 110 volts...but not for 230
Have buy a new one for 120 Euro....works now.....and i sell as soon as a can
The board is really slow ..........take a look around,there is beter for that money

Send Russel two emails.....he don't replay.......well well