TNC 155Q matchmaker parameter Problem - CNCzone.com-The Largest Machinist Community on the net!

Zoni · #1 08-28-2009, 02:35 AM

Hi, I have got a problem. My machine serial communication was not working so I opened the control and removed its card and install the two comunication ICs.
The parameters were rest so I gave the parameters again but after that I have a problem. If i am working with feed rate more than 2000 machine gives gross position error or if it is at the end of table it will over travel. Please guide me where the problem may be and what is the solution

Thanks

jagdeep · #2 08-28-2009, 04:55 AM

take new parameter list and try it

Zoni · #3 08-29-2009, 11:40 AM

Thanks for reply can you send me parameter list and can you tell me that it is due to perameters I have attached the file containing parametrs I have used

jagdeep · #4 08-31-2009, 02:21 AM

Originally Posted by Zoni

Thanks for reply can you send me parameter list and can you tell me that it is due to perameters I have attached the file containing parametrs I have used

i had bridgeport interact 520 with heaidhean tnc 155 machine , i have parameter of that machine will it work for u

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
fanuc 6t parameter problem	moghul	Fanuc	8	12-30-2011 12:59 PM
Matchmaker Cnc Mill Model AN-S	skunge	CNCzone Club House	0	07-06-2009 06:53 AM
Machine parameter problem ...	talash	Machine Problems, Solutions , Wireless DNC, serial port	0	10-09-2008 04:20 AM
Heidenhain 155Q Problem with x and Y axis	Zoni	Machine Problems, Solutions , Wireless DNC, serial port	0	04-05-2008 04:33 AM
Miyano parameter Problem	AFX	Fanuc	12	02-01-2007 01:28 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)