AMAD OCTO-334 "FANUC 6M" _ DNC Settings

[caecae_eng]

Hello,
This is my first post in this forum and I wish to find a solution for my problem here. we have an OCTO machine in our Facility With FANUC 6M Controller. we use Sigma Nest for Nesting and NC code Generation. and we have a problem sendin the code to the machine. if any one have any Experience with this machine please help me I believe my problem is in the DNC software Settings.
Thanks In Advance.

[inventcom]

Hy,
i've added a setup file for a fanuc15m. You can load it into CNCnet DNC (free!) http://cncnetdnc.wieland.us/

Extract the .pp file to the CNCnet DNC \SYSTEM directory,
right click on the machine - Options - load options - select the file.

Be shure that your cable pin assignment is right for the Fanuc (page 60 - manual).
Martin

[Jarwalcot]

Take a look at the attachment...

Good Luck

[inventcom]

Here's the I/O settings from the loaded .pp file, should meet walcot's settings:

[gm3211]

Jarwalcot's says it all and shoudl work with no issues. The screen shot from Inventcom looks to be confusing with software flow for send, receive is hardware. They generally should match both ways.

If you need more help,feel free to give me a ring.