Need Help!- mach 3/controller directions reversed

[cncbcncb]

i'm having a problem with my machine. the last time that i had it running it would jog around with no problem. today i went and turned it on and for whatever reason the directions when i'm running it in jog mode on mach 3 are switched around. back and forth on the x-axis are fine, but the y-axis moves right whether you push right or left, and the z-axis isn't working at all.

All my cable connections seem to be tight and just the way they were before. where should i start looking to fix this?

[jhowelb]

I would be willing to bet that you have wiring problems. At this point you may well have blown drivers as well.

Look for loose / intermittent connections and / or broken wires in the cables.

[jose cortes]

Don't worried, don't be panic, just re-configure the x and y motor signal directions in the config signal motors.

If you steel in need, just let me know and i'll send you some pics to show how handle it.

[cncbcncb]

thank you guys for the suggestions.

i'm really not sure what happened, but it works just fine now. the weird thing is that i didn't do anything. i just turned it all back on to try and figure it out, turned on jog mode and everything is working perfectly again.

so, i don't know what setting i had tripped, but it's fine now. thanks guys.