| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Machine Problems, Solutions , Wireless DNC, serial port Need help with your Machine or need a Machining solutions for , Serial Port, Cable problems between PC and all others DNC problems disucss them here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-14-2007, 06:53 PM
| |||
| |||
I have a Taig mill with a Stepmaster NC SOP-2 controller and running mach3. I've set up the motor outputs, and entered in steps per inch. And all steppers are set on active low. But my machine isn't jogging. And when I go into the diagnostics no LEDs are lighting up on the parrallel port. And Ideas? Thanks for your help  |
|
#2
03-14-2007, 07:05 PM
| ||||
| ||||
| Make sure all the pins are set to port1, and not port 0. Last column in the motor pins screen.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
03-14-2007, 07:18 PM
| |||
| |||
| all the ports are set to port on. but also my enable1 led is always on. could that have anything to do with it. But i have a feeling it is to do with the parrallel port. thanks. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| C++, Win XP, Parallel Port | Zumba | Coding | 7 | 03-29-2012 01:12 PM |
| Where's the parallel port? | cdlenterprises | Mastercam | 23 | 01-20-2007 05:23 PM |
| 2nd PCI Parallel Port | sunmix | Mach Software (ArtSoft software) | 8 | 11-22-2006 02:17 PM |
| Second parallel port? | essa | LinuxCNC (formerly EMC2) | 11 | 04-12-2006 02:18 AM |
| Parallel Port | Shanghyd | Computers and Networking | 1 | 11-22-2004 11:56 AM |
| | |
Linear Mode
