| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Machine Problems, Solutions , Wireless DNC, serial port Need help with your Machine or need a Machining solutions for , Serial Port, Cable problems between PC and all others DNC problems disucss them here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-13-2003, 05:00 AM
| ||||
| ||||
Hi, there are a lot of CNC machines for Glass and Stone out there. I think it would be very usefull to have a Forum for us to talk about Diamond tools, polishing, programming, bas-reliefs, 3D scanning... and so on. Juergen    |
|
#5
04-17-2003, 08:40 PM
| |||
| |||
Anyone have minimum cost estimates on homebrew water jet hookups to cut 1/2 inch thick glass? I have found commercial systems in the 50k range for just the head, compressor and hopper. Who's built a Home Depot version?
__________________ Worry about success, failure takes care of itself. |
| Sponsored Links |
| |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Engraving and carving stone, I'm Confused | foamcutter | General Material Machining Solutions | 11 | 08-03-2006 08:54 AM |
| | |
Linear Mode
