need help getting eia files from mazak m32 - CNCzone.com-The Largest Machinist Community on the net!

kevotron · #1 03-14-2007, 10:12 AM

I have mazacam, CNCPC and I downloaded pc-dnc and I get any of them to pull these eia programs. Now using the same cable I can get mazatrol programs. But these eia programs there is always a misconnect issue or com port problem. Does anyone have any ideas or suggestions? The guy who used to do this left, so they are making me do it and I am not that well versed in these software packages or serial communication. I also have the microdisk box, could i do it with that?

kevotron · #2 03-14-2007, 12:28 PM

I have had the most luck with PC-DNC, it transmits--but then it says it cannot read the data

585integrex1 · #3 03-14-2007, 03:57 PM

i know you have to use the tape button instead of the cmt button. i don't know if that helps.

kevotron · #4 03-15-2007, 07:30 AM

yes, I do know about the tape button. Thats how I am doing it. I have gotten that far, but with pc-dnc it transfers and then says the data is unreadable. I know the program is OK because they are running it. Thanks for the input.

585integrex1 · #5 03-15-2007, 07:43 AM

i am actually argueing with a mazak blue box right now trying to get info from some t2 disks into griffo brothers. keep fightin the good fight.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DXF Files	deanrach	General Metalwork Discussion	1	11-25-2006 12:09 PM
ncp files to dxf or dwg	greenmanor	Laser Engraving & Cutting Machines	0	10-26-2005 10:33 PM
What files	CNCadmin	Mach Software (ArtSoft software)	1	07-08-2005 04:27 AM
DXF or PLT files	signIT	DIY-CNC Router Table Machines	1	07-01-2004 04:57 PM
3D dxf files	NeoMiller	General CAM Discussion	6	11-06-2003 09:42 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)