Need Help! Need Help with Yasnac J300 controller! Alarm codes - CNCzone.com-The Largest Machinist Community on the net!

drutort · #1 08-28-2011, 08:46 PM

I have a Matsuura 510 with a j300 controller.
It was transported and the power has been connected but when the machine was powered on I get the 3 alarm codes.

3002 Emergency Stop
3000 Servo Off
2190 Machine Not ready

Air and oil are in the machine, and the emergency stop has been depressed both on the back of the tool changer and on the front. Have pressed on button on the control 2x

I have hit reset number of times, no luck.

I am not familiar with this controller.

Is there some kind of physical switch or parameter that needs to be turned switched? I do not know the steps that were taken or need to be taken before transportation and after.

Thank you for any feedback.

haastec · #2 11-29-2011, 09:03 AM

Can I ask what you did to clear this?

I have the same issue.

Thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Yasnac lx-1 alarm help	McKinneyMachine	General Metal Working Machines	0	01-27-2011 12:06 PM
Need Help!- yasnac 310:servo off alarm	Nikola	Machine Problems, Solutions , Wireless DNC, serial port	3	01-09-2011 03:02 PM
Alarm 14 on Yasnac Controll	blakemachine	General CNC (Mill and Lathe) Control Software (NC)	9	03-04-2010 06:55 PM
fanuc om controller alarm codes?	Twin-10s	Fanuc	3	08-09-2009 11:47 PM
Need Help!- Yasnac J50M Alarm 330	bluemoon	Machine Problems, Solutions , Wireless DNC, serial port	3	04-29-2009 11:58 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)