Need Help!- Yasnac J300M/J100M

[springer82]

I was doing some surfacing on a Mayano with a Yasnac J300M and wanted to kick it in the butt with High-speed cutting. I put the HON and HOF in the program but only got a error message. It was 0101,,, Address/Data Error. I checked all parameters and they seem to be set right. We have never used high speed machining on this machine before. Does it need to be truned on by a service guy??? What am I missing?? Thanks for your time.

[dcoupar]

Please post the section of the code where you have the HON HOF commands.

[springer82]

I would love to be able to do that but I am at home now. I can tell you that I put the HON in after the G43. Just above the first XYZ move. The HOF is in just before the G91G28Z0 line. Like I said I checked all parameters listed in the programming manual for high speed milling. It all looked good. The only thing I can think of is I need to set a bit to turn on that funtion. ?????