| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Machine Problems, Solutions , Wireless DNC, serial port Need help with your Machine or need a Machining solutions for , Serial Port, Cable problems between PC and all others DNC problems disucss them here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-28-2010, 07:53 AM
| |||
| |||
Hello, I need help with a new-onset error on my OKK with Fanuc OM and PMC, 30x changer. For several days, the automatic tool change is no longer- the arm of swings, the pneumatic switch is safe but in the pneumatic valve for the booster is not steered on. After about 5 seconds then comes the error 2110th But when I press the button for manual tool clamping, the manual change is fine, the Pneumatic Valve and the Booster works fine.? Where can I look for da best, I have checked all the connections already are tight. Greetings from germany, Thomas  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Regestry booster | larry53 | Computers and Networking | 0 | 01-21-2010 07:45 PM |
| PLC stops when solenoid valve activated | Syphonics | General Electronics Discussion | 9 | 09-23-2009 06:59 PM |
| Need a signal booster to make 3.5v logic 5v | Smertrios | General Electronics Discussion | 7 | 02-01-2007 06:13 PM |
| Booster for spindle? | Corvus corax | Mechanical Calculations/Engineering Design | 11 | 12-04-2005 02:34 PM |
| | |
Linear Mode
