can someone make a dxf for me

[bullseye]

I want to engrave this design for a Project and tried CamBam but having trouble figuring it out, can someone convert this for me 6 inchs long x .5 wide DXF

thanks in advance

[mcphill]

That picture is too pixelated to get good edge contrast from it. Do you have a much higher quality image?

[Senna]

bullseye...

I drew it up in Freehand as the original was of poor quality... I've attached the DXF and a PDF just in case...

Happy cutting...!

BOOMER52

[bullseye]

bullseye...

I drew it up in Freehand as the original was of poor quality... I've attached the DXF and a PDF just in case...

Happy cutting...!

BOOMER52

That looks awesome...thanks so much, can you thin it down to 1/2 inch and still keep it 6 inches long..even 5 would be ok

great job...I need to learn more how to draw this stuff up

[Senna]

Easy enough... but what you are asking is a bit unclear. It seems the .5" H is your main dimension requirement... so making this image .5" H results in a width of 3.405" while maintaining the image ratio. Not certain that's what you are asking for so I also included one .5" H X 5.0" W. This required image stretching... it's the ONLY way to give you a .5" H by the requested 5.0" width...

B

[bullseye]

Easy enough... but what you are asking is a bit unclear. It seems the .5" H is your main dimension requirement... so making this image .5" H results in a width of 3.405" while maintaining the image ratio. Not certain that's what you are asking for so I also included one .5" H X 5.0" W. This required image stretching... it's the ONLY way to give you a .5" H by the requested 5.0" width...

B

Thanks...exactly what I want, I tried scaling it but like you said came out 3.405....Thanks a ton