Need Help! DNC (RMT Operation) on Fanuc 16M - Please Help!


Results 1 to 2 of 2

Thread: DNC (RMT Operation) on Fanuc 16M - Please Help!

  1. #1
    Registered
    Join Date
    Aug 2013
    Posts
    6
    Downloads
    0
    Uploads
    0

    Default DNC (RMT Operation) on Fanuc 16M - Please Help!

    Hey everyone! I have a Robodrill t10a with Fanuc 16M control. It was setup for DNC operation previous to us having to replace the PSU. Now I have loaded all parameters, etc and tried to get into RMT (remote) mode but cannot get it to get out of MEM mode and into RMT. Can anyone guide me in the right direction here? I've spent a lot of time this week trying to get it to work. FWIW - I can send a program via RS232 from PC to the MEM in the control, but just can't get it to go to RMT. I don't know if there's a parameter I am missing or what here. HELP!

    Thanks in advance.

    Similar Threads:


  2. #2
    Member whiteriver's Avatar
    Join Date
    Aug 2003
    Location
    United States
    Posts
    318
    Downloads
    0
    Uploads
    0

    Default Re: DNC (RMT Operation) on Fanuc 16M - Please Help!

    Did you ever get this working. I have the same problem.

    thanks,
    Donny



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

DNC (RMT Operation) on Fanuc 16M - Please Help!

DNC (RMT Operation) on Fanuc 16M - Please Help!