What am I doing wrong

[BOBINETTE]

Hi, when using one of the Newfangled Solutions Wizards before going to the wizard I zero the X,Y and Z to the fixture that I want to mill, after filling all the needed parameters and pressing the Post Code button and Exit I am back to the Mach3 screen.

Then when I press he Cycle start button the spindle moves up, but to far up and I have to move the Z back to the fixture again rezero it another time, if for some reason or another I have to move the spindle in another spot I only have to rezero the X and Y the Z is OK.
Hoping to be clear enough
Thank you

[ger21]

It the wizard adding a G43 for tool length compensation?

[BOBINETTE]

Hi, thank you for the reply, is there a way to avoid that G43 from happening other than edit the file every time I use a different wizard and where those the wizard get the length of the tool I don’t recall entering any length of any tool

[ger21]

I don't have a Newfangled License, so can't really help you with that. What does the code look like?

[BOBINETTE]

Hi, with the G43 you struck wright on the button, I must have had wrote it in the offset tool and didn't remembered it.
Thank you