| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
11-04-2007, 12:00 PM
| ||||
| ||||
| No, I think all you can d do with that is jog 1 axis, and press the button to change axis.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)    |
|
#4
11-05-2007, 07:37 PM
| ||||
| ||||
| There's a little info here, at the bottom. http://www.machsupport.com/MachCusto...ls_using_ModIO
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PMC Ladder Upload/Download - Fanuc Powermate D | RLMTS | Machine Problems, Solutions , Wireless DNC, serial port | 9 | 11-19-2011 11:00 AM |
| Feedrate control in EMC2? | pauldkeeton | LinuxCNC (formerly EMC2) | 4 | 11-06-2007 01:14 AM |
| Powermate H servo parameters | Mike Ball | Fanuc | 0 | 05-15-2007 12:01 PM |
| emc and powermate as a jog wheel ?? | harty | LinuxCNC (formerly EMC2) | 2 | 03-14-2006 09:49 PM |
| feedrate oddity | erase42 | DeskCNC Controller Board | 2 | 02-15-2006 11:12 PM |
| | |
Linear Mode
