Help! need someone to help w/ some mach 3 g code programming

[sconklin]

I am currently writing basic g code programs in Mach 3 but need help w/ some that are a bit behond my abilities at this point. I would be happy to pay for some help .I am using a small cnc mil /router
Can anyone point me in the right direction?

[Micro_CNC]

http://www.linuxcnc.org/handbook/gcode/g-code.html

Thats where i started to learn G-Code, It's a generic guide to G-Code.
After that i taught myself by playing with the code produced by the wizards. Learning how to make the machine do helical patterns. Oh, and check out the G and M-code pages on wikipedia.

Regards, Matt

[hug333bear]

Hi, i am not sure if this is the right place to post but i have a g-code problem.
I make designs in artcam and load the g-code generated from it to mach3,problem is. The output's inverted. The only solution i did was to invert it so the result would be normal but it isn't a really good idea work inverted.
Can anyone guide me as to what i can do to solve this problem?