Return to wizard for change

[dave6]

My question is, after I post the G code made by a wizard to the main Mach 2/3 screen, how do I go back to the wizard and change say a step depth or feed rate etc. I am aware that the G code can be edited on the main page of Mach 2/3 but I would rather go back into the wizard that I just created and do the minor adjustments there then repost the code. How is the correct way to do this?

[ger21]

Save the settings in the wizard before you exit it. Unload the code from Mach3, and go back to the wizard. Make changes. Repost code.

[dave6]

Hey thanks,
That sounds simple like me.....