| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-28-2009, 08:56 AM
| |||
| |||
Never heard of PID before this Mach Motion/Mach3 retrofit on my V2XT. I have read the manual (and everything else there is to read) for many hours. Motors are stock SEM servo with stock encoders. Encoders seem to be working fine. I have all the axis input done correctly in Axis Works. I am at the point where I can make the axis move very slowly (in Axis Works) but I'm not sure what my PID objective is. Most everything is written assuming you are already an expert... Anybody have some PID settings I can start with from you similar machine make might make some sense? My Z axis is still jumpy and I still have to figure that one out but like I said Im not quite sure what Im trying to achieve with the tuning or what most of the PID settings are. Just looking for a place to start. Thanks, RonO  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| higher torque 5 start, vs lower torque 2 start | carvemylog | DIY-CNC Router Table Machines | 8 | 03-11-2009 10:44 PM |
| Where to start... | motoguy | General Metalwork Discussion | 3 | 02-22-2009 07:03 AM |
| Arrow 750 Failed to start when I Push start Bottom in fornt of control ! | mte.jalal | Cincinnati CNC | 4 | 01-06-2009 10:20 AM |
| Newbie- one start or two start lead screw | Pinhead | DIY-CNC Router Table Machines | 5 | 11-22-2008 10:32 PM |
| Single start vs double start ballscrew. | darik | Linear and Rotary Motion | 13 | 03-21-2007 07:53 PM |
| | |
Linear Mode
