| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-23-2009, 07:41 PM
| ||||
| ||||
instead of running smoothly through. it ran perfect yesterday and now it runs in about .5" steps. i did not change anything in the mach 3 settings and now are needing this to go away. i can still rapid across the table but when the go button is hit i get steps.? not in one direction but in arcs and all. i assume this is a mach 3 issue because my dolphin gcode program is the same that i used before. thanks   |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| x3 missing steps after program runs | kirker912 | Benchtop Machines | 8 | 08-11-2009 10:32 AM |
| Problem- Engraving Machine losing steps | hopeitworks | Engraving Machines | 0 | 06-08-2009 06:26 AM |
| Loosing Steps, Machine Stall, for no Apparent Reason | JoeDawg | Benchtop Machines | 5 | 12-19-2008 06:47 AM |
| Newbie- Steps to built CNC machine | mastem | General Metal Working Machines | 3 | 03-28-2008 04:30 AM |
| Full Steps -vs- Micro Steps | DJB282000 | General Electronics Discussion | 10 | 12-28-2005 11:25 PM |
| | |
Linear Mode
