| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-15-2009, 08:27 AM
| ||||
| ||||
Hope someone can help with this one, just dont pick my brains to hard as they are getting old. Have been cutting a few jobs with vectric 2dcut with one toolpath, all is good all parts and shapes identical, but when i do a job with more then one toolpath each toolpath is out of alignment with the rest by about 2mm. thanks for any input michael  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| new 3d toolpaths | camtd | GibbsCAM | 0 | 01-01-2009 03:06 PM |
| Need help with toolpaths. | vigilante212 | Mastercam | 9 | 11-14-2007 03:51 PM |
| Toolpaths 101:Version 19 vs. 21 | Zenjon | BobCad-Cam | 12 | 07-30-2007 06:17 PM |
| Creating Toolpaths for IGS | dneisler | Mastercam | 1 | 01-14-2007 08:37 AM |
| OMG all the toolpaths!!! | dbtoutfit | General CAM Discussion | 6 | 06-18-2006 12:42 PM |
| | |
Linear Mode
