| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-15-2009, 01:42 PM
| ||||
| ||||
Hi. I am trying to move my Mach3 install to a dedicated computer and I cannot seems to get a functional setup. This is how I do it. 1 - Install mach3 2 - copy previous mach3 folder completele ontop of the new one. I have done a lot of configurations and when I open Mach3 Mill on my new computer there are no configurations done at all. I wish I just copy the configurations ports/pins/motor tuning and cant figure out how.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- config pin in mach3 for co2 laser | tessen | Laser Engraving & Cutting Machines | 7 | 11-12-2008 01:34 PM |
| Config Mach3 for coolant | BrassBuilder | Benchtop Machines | 4 | 08-19-2008 05:53 AM |
| Steps per/mach3 config | bp092 | Gecko Drives | 2 | 02-22-2008 12:49 PM |
| Need Help!- Config Mach3 | rex2 | Machines running Mach Software | 0 | 01-26-2008 03:52 PM |
| G-Rex100 and Mach3 Help on I\O Config | cybertek | Mach Software (ArtSoft software) | 2 | 01-02-2007 10:39 AM |
| | |
Linear Mode
