| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-01-2009, 12:31 AM
| |||
| |||
do they get along ok? I,m having a problem with torque on my 3 axis machine, Every thing jogs and will cut air fine but when it plunges into the material it stalls. I have 3 axis xylotex with dampeners, running 425's, I have a nvidia video card and was told that may be my problem. I am running the machine at about 140 ipm, it work ok before but I rebuilt my gantry and now its acting up, there's no binding, have checked by hand and they all run fine. Any ideas would be great full. Graham  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mach3 and PCI port Card | Six0GTO | Mach Mill | 10 | 02-22-2010 04:08 PM |
| Need Help!- Losing mind. parallel card/mach3/xylotex... please help! | nate | General Electronics Discussion | 0 | 06-07-2008 08:51 PM |
| Mach3 and external PCI parallel card? | Cooper | Mach Mill | 4 | 12-11-2006 12:26 PM |
| | |
Linear Mode
