| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#3
 
04-30-2009, 01:57 PM
| |||
| |||
| You should view the tutorial videos on the Artsoft website, read the manual, and check the forums there. As far as the HobbyCnc pay attention to the pin numbers for DIR and STEP. Look directly at the board, it is printed there. These are different than the default Mach3 set-up, you have to change them in the Pins and Ports page. This is a common problem that seems to sucker a lot of people. To answer your question further more information is needed, like what exactly are you asking? Be specific.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Current Reduction, HobbyCNC - Mach3 | gacrwell | Joes CNC Model 2006 | 38 | 02-27-2012 06:20 PM |
| Current Reduction, HobbyCNC - Mach3 | gacrwell | General Electronics Discussion | 0 | 07-12-2007 11:35 PM |
| Hobbycnc kit | dfurlano | Stepper Motors and Drives | 6 | 05-09-2006 09:42 AM |
| | |
Linear Mode
