| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-19-2009, 06:27 AM
| |||
| |||
Hey everyone need a bit of help. I started setting up my heiz in mach3, i came to move the x axis and suddenly the control box started smoking and stopped working ! Heiz have replaced the box. However i think i may have made a mistake in the port's and pins config. Would anyone help me out, from the following diagrams? Heiz don't make it too clear. These are the only diagrams that are supplied.      |
|
#3
04-20-2009, 05:25 PM
| |||
| |||
| Do you have a BOB (Break out board)? Generally the problem most people have is not using a separate power supply for controlling the spindle. I don't think you've given us enough information...therefore few replies. Paul |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mach 2-3 pin&port problem | pislik | DIY-CNC Router Table Machines | 10 | 01-05-2012 02:36 AM |
| Newbie- Heiz or MDL-2-TR? | No1_sonuk | Commercial CNC Wood Routers | 0 | 01-19-2009 10:46 AM |
| Heiz (High-Z S-1000/T) - any experiences? | Sentinel | Commercial CNC Wood Routers | 6 | 12-17-2007 09:55 PM |
| Heiz CNC FORUM in English ?? | westcorner | Commercial CNC Wood Routers | 0 | 03-09-2007 03:20 PM |
| MACH 1.90.065 "Nedd port and pin settings | over60 | Mach Mill | 8 | 08-07-2006 07:32 PM |
| | |
Linear Mode
