Need Help!- BRAIN FART ????

[SPEEDRE]

I must be brain dead or something. Here's what I want to do; I want to begin my cycle at, point " A " , traverse to point " B ", begin my cutting at point "B", and the end at point "A" again so I can flip it and begin again. I used VCarve to make the code it works fine in dry run. When I tried to run it for real the machine sends it in another direction. How can I make it do what I want it to do. I also have Mach 3 and I hope it's configured correctly. I drew the part in the way it shows in the image. If I have to write a few lines of code or substitute ok, but, please give them to me as I can't write code on my own. I guess I've forgotten how to set this up. HELP !
I've atatched a pdf , and the code to illustrate.

[hipdog]

can you invert axis?

[SPEEDRE]

I'm not sure what you mean. If by that you mean turn the material 90 degrees, no I can not. If you mean switch the direction of movement , How do I do that??

[hipdog]

i mean invert the axis on the machine email me @ hipdog1@yahoo.com

[SPEEDRE]

I think I might have been to hasty to panic. I may still need assistance but I think I need to run a few tests first. Yes I do know how ,to change the direction of the axis. I'll run some programs tomorrow a.m. and get back to you by email thanks.

[SPEEDRE]

I have discovered a few thing that may be affecting me. I seem to get an occasional spike in my electric power service. I believes that this, coupled with the idea that my computer system may not be stable, may be two factors influencing these issues. To the moderator, pleases feel free to delete this thread. Thank you