| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
 
12-27-2004, 04:06 AM
| |||
| |||
| Check out the Mach2 manual, section 5. It shows how to configure the ports, giving some info on pin assignments. It uses pins 2-7 inclusive as step/dir outputs for three axis. You can pretty much read the other pin numbers of of the screenshots.
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Engraving Software | The Wizard | General CAM Discussion | 31 | 03-29-2005 06:38 AM |
| mach2 software | vvv | Mach Software (ArtSoft software) | 2 | 07-16-2004 05:39 PM |
| Software sales or "license transfers" | metlmunchr | BobCad-Cam | 3 | 07-05-2004 05:47 PM |
| ***One stop CNC software guide*** | ynneb | DIY-CNC Router Table Machines | 4 | 05-27-2004 05:31 PM |
| | |
configuring mach2 software 
Linear Mode
