| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-04-2004, 03:19 PM
| |||
| |||
I am about to hook-up Mach 2 to the Camtronics controller on my Bridgemill (2004). Is there a wiring diagram for the correct pinout or is the Mach 2 program already set up to drive this controller?    |
|
#2
12-04-2004, 11:51 PM
| ||||
| ||||
| You can configure Mach 2's step and direction output to a number of different pins on the 25 pin printer port. You need to find out which pins your Camtronics controller uses. Once you know this then you can configure Mach 2 to match it.
__________________ Thanks Jeff Davis (HomeCNC) http://www.homecnc.info (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Mach 2 configuration help for Sherline 5410 | wilit | Mach Mill | 14 | 01-15-2010 08:06 AM |
| Mach / geckos or DTLLC drivers | zcases | Mach Software (ArtSoft software) | 3 | 01-11-2007 08:06 PM |
| Mach 2 and settings | tauscnc | Commercial CNC Wood Routers | 4 | 05-25-2005 10:05 AM |
| Mach 2 slow on Intel Centrino P1.6 Notebook | daddyhobby | Mach Software (ArtSoft software) | 7 | 03-28-2005 08:33 AM |
| Proper Computer and Chip for Mach 1 | HomeCNC | Mach Software (ArtSoft software) | 12 | 03-17-2004 10:14 PM |
| | |
Mach 2 / Camtronics Compatibility 
Linear Mode
