Newbie raster xy and yx in Lazycam - CNCzone.com-The Largest Machinist Community on the net!

12-14-2008, 04:52 PM

pistolknight pistolknight is offline

Join Date: Jul 2007

Location: uk

Posts: 17

raster xy and yx in Lazycam

permalink

Hi, i'm trying to make a few lithophanes using photographs imported into Lazycam.
My question is, can I import the image and raster it in the xy plane and cut it, then return to the start point, raster it in yx and then cut it again? Would this be possible and if so, would it improve the finished article? I think it would as surely it would turn the minute lines into minute squares. Any help would be greatly appreciated.

Regards,
David

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Smart Raster	zoltan	Laser Engraving & Cutting Machines	3	03-11-2008 12:53 AM
Raster to vector	lez	Printing, Scanners, Vinyl cutting and Plotters	4	01-06-2007 10:54 PM
Raster To Vector (R2V)	tknief	CNCzone Club House	2	09-28-2006 10:46 AM
OneCnc Raster to Vector	partsman	OneCNC	1	01-24-2006 12:38 PM
raster to vector	teilhardo	General CAM Discussion	9	05-05-2004 08:56 AM

All times are GMT -5. The time now is 10:59 PM.