| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
10-12-2004, 07:31 PM
| ||||
| ||||
My router is way too noisy for my liking, (probably my neighbours too). I have a 3 phase motor, (nice and quiet) + VF phase inverter, and was wondering if I could control it from Mach2. I know it'll work Ok on it's own, and I can control the variable frequency manually on the inverter, but it'd be nice if mach2 can control the motor speed via the remote connection of the inverter. The inverter is made by Eurotherm. 601 series (I think). Anyone have any expirience of this type of setup. Regards Terry...    |
|
#2
10-12-2004, 08:13 PM
| ||||
| ||||
| If you buy the spindle speed control board from http://www.campbelldesigns.com , it will convert Mach 2 step and direction speed control to voltage to drive your VFD, so yes it can, but it will cost a little extra. Go to the website and read the .pdf. It has the info you need there. I think I saw $75.00, btw
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
10-12-2004, 08:15 PM
| ||||
| ||||
| After quickly browsing throught the .pdf, you may also need the Campbell breakout board as well.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#4
10-12-2004, 08:20 PM
| ||||
| ||||
| Thanks for the useful info. I'll set it up for manual control for now and see how it goes. When Christmas is out of the way and I have some spare cash, I'll be looking at buying the parts you pointed out. Regards Terry... |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Visual Basic Controller Project | dwwright | Visual Basic | 29 | 02-14-2011 02:24 PM |
| VFD for a single Phase motor!! | Yepez | Servo Motors and Drives | 4 | 08-10-2009 07:53 PM |
| Staggering motors | viktorcnc | Stepper Motors and Drives | 12 | 10-12-2005 05:56 AM |
| newer mach2 version, no spindle control now?? | yukonho | Mach Software (ArtSoft software) | 4 | 05-08-2005 02:47 PM |
| Mach2 remote control | steveald | Mach Software (ArtSoft software) | 1 | 01-19-2004 09:20 AM |
| | |
Linear Mode
