| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-27-2004, 04:08 PM
| |||
| |||
For some reason this version wont run g-code and wont accept manual input of single lines of g-code. However the jog controls work and send accurate (yet kinda jumpy) steps to the servos. Is there something thats needed for this to be fixed.     |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Oriental Motors Alpha system | ddgman2001 | Gecko Drives | 0 | 04-17-2004 01:38 PM |
| | |
Linear Mode
