| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-24-2007, 10:02 AM
| |||
| |||
I know to use my arrow keys for X and Y but I cannot figure how to jog my spindle up and down. Can someone tell me?  |
|
#2
04-24-2007, 10:11 AM
| ||||
| ||||
| What type of machine is it please and are you programming in ABS or CAR? For example, on my turret mill to jog the Z say 0.1mm into the part from where it was I have to manualy lower the bit and reset Z0, but on my Diamond Turning lathe I just tell it to machine at 0.1mm into the part by "lying" to it that the part is thinner than it beleives it to be.
__________________ I love deadlines- I like the whooshing sound they make as they fly by. |
|
#3
04-24-2007, 10:22 AM
| ||||
| ||||
| page up/page down.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#4
04-24-2007, 11:20 AM
| |||
| |||
| page up/page down. Thank you. Forgot those keys even existed. Now I won't dump my router on the floor. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
