| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-21-2007, 07:20 PM
| |||
| |||
Hey Guys: Any way to make this work? N5G00G20G17G90G40G49G80 N6G49 N7T1M06 ( Twist Drill / Center Drill ) N8G00G43Z-1.9685H1 N9S1000M03 N10G94 N11G99G81X2.38Y-1.18Z0.15R-0.1181F15.0 Mach3 complains that on the last line, the R value is less than the Z value, which it is. But I have my Z axis values reversed so R= -0.1181 is actually .1181 above the work piece. And I want to drill down 0.15 in the Z. But I can not figure out how to make this happen. Thanks  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| problem drilling tiny holes | gilessim | Steam Engines | 7 | 05-26-2009 05:04 PM |
| Canned cycle face turn problem | Wiseco | FeatureCAM CAD/CAM | 9 | 12-22-2008 01:30 PM |
| G90/G91 in canned cycles | alfalfa | CamSoft Products | 18 | 02-25-2007 05:20 AM |
| drilling and drilling cycles tutorial | wmorre | General Metalwork Discussion | 0 | 10-18-2006 06:30 PM |
| Daewoo puma 12L fanuc ot drilling canned cycle | burnin daylight | G-Code Programing | 6 | 08-27-2006 05:26 PM |
| | |
Linear Mode
