Works in KCam, Not working in Mach3 - CNCzone.com-The Largest Machinist Community on the net!

Cooper · #1 02-28-2007, 04:26 AM

Dear All,

I bought my cnc controller yesterday and i connect everything as in manual. The board works very well in Kcam (Kcam is explained in manual and i configured this program works very well). But i would like to buy Mach3 and so i need to configure it for Mach3. I took this ss from related softwares :

Mach3 : (Not Working)

KCam : (Works well)

So, what's the point? What is wrong with these configuration?

TIA

Cooper

7ofclubs · #2 03-11-2007, 11:33 AM

I got the same problem. I got a hobby cnc system, works fine in KCAM and TurboCNC but I can't get it to work in Mach3. I prefer Mach3 because I don't have to restart in DOS everytime I want to mill something.

-=7ofclubs=-

7ofclubs · #3 03-11-2007, 11:41 AM

Looking through the posts here on CNCZone I found a thread that will probably solve both our problems.

You can find the thread at:

http://www.cnczone.com/forums/showthread.php?t=32883

-=7ofclubs=-

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Kcam 4	mwestern	Kellyware CAM	36	09-10-2007 08:15 AM
Mach2 to Mach3 not working......	Normsthename	Mach Mill	3	01-23-2007 01:34 PM
KCAM CNC Controls No go	oliverthepig	General CNC (Mill and Lathe) Control Software (NC)	0	06-03-2006 07:54 PM
Tool Comp not working in Mach3	Dennis Fletcher	Mach Software (ArtSoft software)	3	03-08-2006 08:24 PM
KCam.ini	pminmo	Kellyware CAM	1	06-12-2004 01:30 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)