Mach3 console?

[RLC]

Hello All,
I’m currently building new controls for an RF31 mill/drill. I will be using mach3 for software. I have seen a couple of control panels out there that have hardwired buttons, joysticks and MPG’s in conjunction with the keyboard/mouse. I was wanting to a rotary switch to select the axis and another to select jog mode, then use a joystick for the actual jogging. And was wondering if this is possible or if anyone can point me to a thread or website that’s has some information on what I’m wanting to accomplish.

[ger21]

http://www.machsupport.com/MachCusto...n_case_studies

[RLC]

Gerry,
Thanks for the quick reply, and pointing me in the right direction....that is what I was looking to do.