| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-14-2006, 11:49 PM
| |||
| |||
I have a strange problem & hope someone can help. I have been using Mach2 for a while and everything was fine until I crashed the Z axis and replaced it. Now when I use the "Reference All" button the Y & Z axis seem to work OK but the X only moves a little and the DRO goes to 0.00 right away. The strange thing is that when I run a program my G28.1 commands work fine, all axis go in the minus direction, hit the switch and sets the DRO's to 0.00. What is going on with the "Reference All" button?? Any ideas? Thanks in advance, Marcos (elalto)    |
|
#2
09-15-2006, 08:28 PM
| ||||
| ||||
| Check the diagnostics page. Is the LED for the X home switch coming on? maybe your getting noise on the X home switch.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
