Jogging the Z Axis in Mach2

[DaSigntist]

Does anyone know how to jog the Z Axis in Mach2?
What I'm doing now is changing the pins over with the X axis moving the Z and then change them back = Big Pain

I can seem to find a referance to it in the manual.

[DaSigntist]

Oops! sorry found out using the Hot Key setup!

[gcamlibel]

I am using mach2 too. I use a 3 axis 2 button joystick to jog X and Y axises. However I can not jog Z axis via joystick.

I couldn't find any setup menu about joystick at Mach2. Is it possible to use 3th axis of joystick for z axis control?

[tsomer]

Try using "page-up" and "page down." It's reasonably intuitive. I don't know if it is a default setting, but you could set it up in keyboard shortcuts menu.

[strat]

howdy newbie here but i'm using an old suncom f15 tri axis joystick you can "program" the axis/switchs to the key stroke you want simulated the way mines setup is main joy controls x/y axis 2 is set up z+/z- x+/x- and axis 3 is y+/y-
would like to "enable" the spindle on off to the trigger key but no luck on this yet

[Art Fenerty]

Use the joystick setup for your stick to make the trigger put out the hotkey for Spindle Toggle. (On whatever screen you use..)

Thanks,
Art