| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-09-2006, 09:13 AM
| ||||
| ||||
I'm trying to load the shuttlepro plugin into my system. I have been given directions to load the software into the mach3 "plugin" folder. That would not be a problem if I could find it!!!! Is there a reason my mach3 folder would not have a pluging folder????? Thx. Bill 
__________________ billyjack Helicopter def. = Bunch of spare parts flying in close formation! USAF 1974 ;>)    |
|
#2
09-09-2006, 09:44 AM
| ||||
| ||||
| You're using an older version of Mach3 that probably doesn't support plugins
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
