| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-26-2006, 12:04 AM
| |||
| |||
I just got a Logitech wireless Rumblepad 2 controller and am trying to interface it with Mach 3. I'm having trouble. I assigned a couple of buttons on the controller to keyboard buttons, to jog in Mach 3, with the software that comes with the controller. The problem is that when I run Mach 3 with the Logitech software running I cannot jog, even with the keyboard. If I shut down the Logitech software and restart Mach 3 I can then jog again with the keyboard. Help! Is there some setting or something I need to do in Mach 3 to get it to recognize a controller or joystick? Does anybody else use this type of controller successfully with Mach 3? Thanks    |
|
#3
05-26-2006, 05:57 PM
| ||||
| ||||
| Try using Keygrabber that comes with Mach3.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
