| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-06-2006, 06:25 AM
| |||
| |||
Hello.. Looking at putting on a Rotary Tool Changer (a Axis) and was wondering what is required in Mach2 to achieve this... Is there any Macros etc required and if so how can I obtain the necesary macros?.. thanks Frans    |
|
#2
05-06-2006, 09:36 AM
| ||||
| ||||
| You'll most likely have to right your own macro, or pay someone to write it for you. You should be able to find some similar macros at either the Yahoo support group, or Mach's new forum at www. machsupport.com
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#4
05-08-2006, 05:02 AM
| |||
| |||
| Is this the link you're refering to Denis? http://www.machsupport.com/videos.htm |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
