Where to change axis directions?

[WarrenW]

I have my axis directions setup wrong in Mach3 and cannot see where to reverse them anywhere. It was probably right in front of me!

When I jog X- it goes away from the bottom left corner. And I may have Y set wrong too.

Thanks,

Warren

[joecnc2006]

I have my axis directions setup wrong in Mach3 and cannot see where to reverse them anywhere. It was probably right in front of me!

When I jog X- it goes away from the bottom left corner. And I may have Y set wrong too.

Thanks,

Warren

look under config / homing

[Art Fenerty]

Hi Warren:

Change it in the Config/homing and limits. Check the "reversed" box..

Thanks
Art

[bdrmachine]

What is your reference? The motion is based on tool travel. A +X tool motion on my cnc machine is caused by a table motion in the opposite direction (-X). Comming from a manual machine this seamed to be backwards to me at first but it all makes sense now.