| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-11-2005, 07:04 AM
| |||
| |||
I would like to migrate to mach 3 from mach 2. My holdup is that I need to keep the default mach 2 standard run screen, which I have not been able to find. The Mach 3 default screen is different and doesn't include all the functions I have been using. I expect I could make a new screen given enough time but just need the simple layout. Thanks Carl  |
|
#2
12-11-2005, 07:18 AM
| ||||
| ||||
| I have a copy of Mach3 R1.0 which might still have the old screens, but I'm not sure. PM me your email address and I'll send it to you. You'd have to install it, and back up the screen files, then install the latest and load the old screens. But, again, I'm not sure if it's in there though.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
