I need to physically move the x and y jog controls on the screen of Mach 3. I feel like I am driving a car in England on the wrong side. The controls are correct but do not match how I am looking at my table. I downloaded Mach 3 screen editor and I can find the main screen but for the life of me I cannot find the jog control screen in order to just move the position of the buttons. Any help would be greatly appreciated.
Mach3 2010 Screenset
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I found my solution. I was advised to look at page 50 of the main file and I was able to access the jog screen. All is good and up and running.