| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-18-2005, 08:48 AM
| |||
| |||
Hi, i'm very satisfied with Mach2, working fine with it, and would want to set up/build a digitizing probe. I'm not sure where to get a probe that's cheap enough, so maybe i might try building my own. Can you guys help me? Thanks!  |
|
#2
11-18-2005, 09:03 AM
| ||||
| ||||
| http://www.indoor.flyer.co.uk/probe.htm There is also some info in the files section of the TurboCNC Yahoo group. Look for "simple probe".
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#4
11-19-2005, 08:52 AM
| ||||
| ||||
| You can wire it like a limit switch. One side to an input pin, and the other to ground. You may have to use a 5V source and pull up resistor, though.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
