| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mach Software (ArtSoft software) Discuss Mach 1 , 2 and the new Mach3 here NC software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
11-09-2005, 06:43 AM
| ||||
| ||||
| It should, but maybe your plunges are too short to notice the difference. Try adding a Fx.xx to the plunge lines of code to the speed you want. You'll have to add one to the following lines as well for the cutting speed.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)  |
|
#4
11-12-2005, 07:19 AM
| ||||
| ||||
| Do you mean 1000mm/min? Or is your machine plunging into the work at 1 meter per second?  How much travel does the Z-axis have? It's probably too short to even get up to 1000 mmm/min.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#6
11-14-2005, 06:44 AM
| ||||
| ||||
| How far does it move?
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
